Dock Hardware

Tiedown Engineering Male T Connector Inhin 26408H. Use with Female T connector to attach fingers and ramps. Bolt set "N" required for joint.

Tiedown Engineering Male T-Connector 26532H. Use with Female T connector to attach fingers and ramps. Bolt set "N" required for joint.

Tiedown Engineering O/S Corner Male 10 25491B. Use with a female outside corner to connect docks end to end. Joint requires 3/4" bolt set (N) or connector pin (O). Each leg is 10"L x 5" H.

Tiedown Engineering Outside Corner (Female) 26521A. Two 1/2" welded tabs. Use with a male outside corner.Each leg is 10"L x 5"H.

Tiedown Engineering Outside Corner (Male) 26522B. Use with a female outside corner to connect docks end to end. Joint requires 3/4" bolt set (N) or connector pin (O). Each leg is 10"L x 5" H.

Tiedown Engineering Outside Corner 1.5 26428C. Use this corner at ends of fingers and docks. Ideal for swim floats and ski jump corners.

Tiedown Engineering Outside Corner End 26523C. Use this corner at ends of fingers and docks. Ideal for swim floats and ski jump corners.

Tiedown Engineering Outside Corner Male W-Tab 26418B. Use with a female outside corner to connect docks end to end. Joint requires 3/4" bolt set (N) or connector pin (O). Each leg is 10"L x 5" H.

Tiedown Engineering Pile Chain Holder 26419For use as a pile holder with 3/8" galvanized chain and shackles. Can be adjusted for various pile diameters.

Tiedown Engineering Piling Hoop 10 26391Heavy duty 1/4" galvanized steel. 3" high. Can bolt to the dock directly or to an optional deck plate (26416).

Tiedown Engineering Piling Hoop 12 26394Heavy duty 1/4" galvanized steel. 3" high. Can bolt to the dock directly or to an optional deck plate (26416).

Tiedown Engineering Piling Hoop 14 26393Heavy duty 1/4" galvanized steel. 3" high. Can bolt to the dock directly or to an optional deck plate (26416).

Tiedown Engineering Piling Hoop 14 with Roller 26423Commercial grade steel. The piling hoop secures around the piling, while roller permits smooth up and down movement. 22.5" Width.

Tiedown Engineering Pipe Holder 3" Comm. Grade 26411K. Bolts to outside of dock. Uses 2" pipe to hold dock in place. Carriage bolt set "M" required for attaching.

Tiedown Engineering Pipe Holder-Outside 3" Std 24280K. Bolts to outside of dock. Uses 2" pipe to hold dock in place. Carriage bolt set "M" required for attaching.

Tiedown Engineering Washer Plate Commercial Grade 26409I. Should be used with every Angle. Two required for each Angle. 1-1/2"L x 5"H.

Tiedown Engineering Washer Plate-Standard Grade 24284I. Should be used with every Angle. Two required for each Angle. 1-1/2"L x 5"H.