Boat Outfitting

Taylor 11In Windshield Support Bar 1632Used as original equipment on many walk-thru windshields. Made from anodized aluminum tubing with nylon fittings. They allow for pivot in almost every direction for easy installation. Sold individually.

Attwood Marine Deluxe Cover Support System 10795-4Easily adjustable. Pole rests on a rubber foot and the web straps attach to the stern with non marring hooks.System Includes:1" diameter aluminum telescoping center pole (28" to 48") Adjustable 1" wide...

Attwood Marine Flush Mount Base For Rod Holdr 5071-3Fit a variety of mounting surfaces including rails. Constructed of extruded aluminum.

Attwood Marine Flush Mount Rod Holder 0 Deg SS 66364W7Attwood stainless steel rod holders feature a U.V-resistant polymer liner that protects the finish on rod and reel and a U.V-resistant cover cap/gasket that closes the tube when not in use. Open-end...

Attwood Marine Rod Holder-Heavy Duty White 5009W4Features a superior ergonomic design and easy to find rapid release latch mechanism. The large, easy-grip lock-nut offers easy adjustment. 180°, vertical adjustment range for a variety of rod tip height...

Carver Covers 2' Slide Track Kit 1Pr/Pk 62000Allows retracted top to slide into storage position, as an alternative to a brace kit. Each kit includes 2 slidetracks, 2 sliding deck hinges with combined slide locks, 4 end caps and all mounting screws.

Carver Covers 4' Slide Track Kit 1Pr/Pk 62002 Allows retracted top to slide into storage position, as an alternative to a brace kit. Each kit includes 2 slidetracks, 2 sliding deck hinges with combined slide locks, 4 end caps and all mounting screws.

Johnson Pump 5.2 gpm 12V Baitwell Pump 1013252107Bw 5-chamber diaphragm pump designed for continuous duty. Features dramatically lower noise & water pulsation compared to 3 or 4 chamber designs. Self-priming to 6.5' (8.2' for 5.2 GPM model)...

Johnson Pump Shims 1 Pr/Pk 712457410500: Plastic mesh , fastening clamp included77125: Two-piece filter, easily installs by placing the mounting base under the aerator thru hull nut and then tightening the nut. Twist off to remove for easy cleaning.

Kuuma 11 Gallon Marine Water Heater - 120V Rear Heat Exchanger, L1&N Wiring 11842 Kuuma's 11-Gallon Marine Water Heater provides your boat with an ample supply of hot water. This 11-gallon capacity premium water heater has an electrical input of...

Kuuma LP Gas Regulator for Kettle 125 and Profile 150 Gas Grills 58355 Replacement LP gas regulator. Compatible With: Kuuma Kettle Grill Kuuma Model 58121 (Profile 150) Kumma Model 58245 (Profile Cubed 150)   

Rule General Purpose Pump 12V 17ADesigned for use as a washdown pump and/or to circulate water to your livewell tank(s). Heavy-duty submersible construction for use on commercial or pleasure boats. Must be mounted below the waterline. It does not deliver...

Sea-Dog Line Head Screw 273568- These Jaw Slide & Bracket Fittings are components in a Bimini top fitting system. Bracket Fittings are designed to mount on the side of the gunnel for a jaw slide to snap onto. The jaw slide then glides along the...

Sea-Dog Line MRV Wiper (Black) 412121W-3 MRV Wiper Motors are a two-speed, self-parking heavy duty motor for interior/protected locations. Sweep angle is preset at 80° or 110°, but can be reset to 40°, 50°, 60°, 70°, 80°,...

Sea-Dog Line MRV Wiper Motor (Black) 412178B-3 MRV Wiper Motors are a two-speed, self-parking heavy duty motor for interior/protected locations. Sweep angle is preset at 80° or 110°, but can be reset to 40°, 50°, 60°, 70°,...

Sea-Dog Line Nylon Angled Deck Hinge (Black) 273230-1 Deck Hinges are designed to mount horizontally and attach an eye end secured to tubing in Bimini top applications. Concave Hinges are designed to rail mount on 7/8” tubing. Angled Hinges are...

Sea-Dog Line Square Tube Jaw Slide (Black) 273560-1 These Slide Fittings are used as part of a Bimini top system to install a new Bimini top to boat rails or for adding additional support arms to an existing top. Jaw Slides attach an eye end securely to...

Sea-Dog Line Three Pole Rod Strg Rack Black 325039-1One-piece injection molded UV stabilized polypropylene. No assembly, easy installation. Side mount, hardware (four #8 stainless screws) included.3250281 & 3250291 have tackle slots & a slot to hold a...

Sea-Dog Line Toggle Pin & Lanyard Straight 299986-1 L-shaped Toggle Pin features a swivel flip lock for use with Bimini top hardware. For added security, the hinge prevents the 1/4” pin from being withdrawn from the fitting until the locking...

Sea-Dog Line Wiper Blade Straight Blade Style Arm (Black) 414222B-1 These deluxe curved Wiper Blades feature a marine grade silicone rubber squeegee. For use on flat or curved windshields with a straight blade style arm. Constructed of corrosion...