Hardware

Attwood Marine Thru Hull SS 3/4" Short 66541-3 Cast from 316 stainless steel. A channel under the flange holds a bead of sealant. All models have wrench flats or an end notch. Designed for installation above the water line only. Lifetime warranty.

Attwood Marine Thru Hull SS 5/8" 66546-3Cast from 316 stainless steel. A channel under the flange holds a bead of sealant. All models have wrench flats or an end notch. Designed for installation above the water line only. Lifetime warranty.

Attwood Marine Thru-Hull 1 1/8" 3874-3Molded of rugged plastic. Will not rust, corrode, discolor or contribute to electrolysis. Design eliminates hull streaking and allows countersinking wherever a flush fit is required. White.

Beckson Marine 24 Hand Pump with 24 Hose 124Pf Self-priming and self-lubricating. Easy to clean. Will not mar boat. Solvent welded construction. Will withstand temperature to 120°. Special all polyvinyl body and shaft. Non-conductive, non-corrosive...

Beckson Marine 4 Screw-On Vent Hose Adapter Sa-4 Designed for attaching ventilation hose to deck for use with Beckson "C" series vents.

Beckson Marine Deckplate 6" White Screw Nonski Dp64-W Beckson screw-out plates provide access without the use of tools, with a single start, non-jamming (no cross-thread), extra strong, self-cleaning buttress thread. A self-aligning center and an...

Beckson Marine 8 White Pry-Out Diamond Nonskid Dp85-WAn extra heavy "O" ring to assure watertight fit. To be installed in areas where internal pressure (oil-canning) is NOT present. Ideal for inspection compartments, for clean out or access to shut off...

Beckson Marine Deckplate 8" Neu Pry Nonskid Dp85NAn extra heavy "O" ring to assure watertight fit. To be installed in areas where internal pressure (oil-canning) is NOT present. Ideal for inspection compartments, for clean out or access to shut off...

Beckson Marine Hand Pump 18" 118P Self-priming and self-lubricating. Easy to clean. Will not mar boat. Solvent welded construction. Will withstand temperature to 120°. Special all polyvinyl body and shaft. Non-conductive, non-corrosive. With seal.

Beckson Marine Port Opening White/Clear 5 x 12" Po512Dwc20 Designed primarily for cabin sides with excessive angles and where other ports would collect rain and spray. Rain drain ports can be mounted on vertical surfaces with no more than 45&deg,...

Beckson Marine Port White/Clear 4X10 1"sp Po410Wc10Designed with drain molded on inside of spigot. Promotes drainage without angle cuts in hull. Allow for thru-bolting. Seats tightly against gasket and lens omitting internal water retention ledge. No...

Beckson Marine Soft Cowl Vent 4-1/2X4-3/4X2-1/4 Sc-7PVC. Ideal for areas where vent will be under foot or foul lines.

Bomar Hatch Access 10X20 Cream G7102022Molded of high impact UV stable polypropylene. Hatch is low profile for floor mounting. No screws are visible from the exterior. Hatch opens 180°. Has a strong lid with support bars and a double gasket for...

Bomar Hatch Low Pro 16-1/2 x 16-1/2 N107010AStyle A-external hinge. Anodized heavy-duty aluminum frames. Heavy-duty acrylic top. No sharp corners to snag lines or sails. Heavy-duty hinges, quick acting, adjustable tie down dogs. Locked vent position.

Bomar S616 SS Port with Scrn Tab Ring S616Mbss   Polished stainless steel Friction hinge for opening in any position Complete with outside finishing ring Smoked acrylic with polished edges Internal mounting holes Adjustable quick dogs

1" Bronze Flanged Full Flow Seacock Features: 1-1/4" sizes and larger include one grease zerk fitting for lubrication (use only with the valve in the open position), and one drain plug. The zerk can also be used for draining. Tri-flange base and mount...

1-1/2" Bronze In-Line Check Valve Features: C83600 cast bronze construction NPT threaded ports 1/2" - 2" sizes Suitable for use with diesel fuel or gasoline

1-1/4" Bronze Flanged Full Flow Seacock Features: 1-1/4" sizes and larger include one grease zerk fitting for lubrication (use only with the valve in the open position), and one drain plug. The zerk can also be used for draining. Tri-flange base and...

1-1/4" Bronze Tri-Flanged Ball Valve/Seacock Features: 1-1/4" sizes and larger include one grease zerk fitting for lubrication (use only with the valve in the open position), and one drain plug The zerk can also be used for draining Field...

2" Bronze NPS to NPT Flange Adapter IBVF Flanged Adapters have been developed to address several common problems in the marine industry.   Features:   Eliminate dangerous thread miss-match when in-line valves are screwed onto thru hulls Accept...